REDUCED WATER PRESSURE? Increase your water pressure with a water pressure booster pump system.
THE SOLUTION to increased water pressure?
Hi-Tec Plumbing’s booster pump system solution is suitable for distributing water under pressure in residential housing and small-scale agricultural and industrial applications where the incoming municipal water supply pressure is inadequate. The pumps are suitable for handling clean water without abrasive particles and fluids which are not chemically aggressive to the pump components. The special operating system makes our water booster pumps an appropriate solution in all cases where water flow rates do not ensure suitable operating pressures.
- Model: QB70-EPS
- Max Flow rate : 50 l/m
- Head: 48 m
- Suction: max ~8m
- Max Pressure: 4.8 Bar
- Voltage : 220~240v 50hz
- Power: 0.55kw, 0.7hp, 2900rpm
- Rated Flow rate up to 28 l/m
- Inlet 1 inch, outlet 1 inch
A water holding tank (size depended on requirements) and booster pump are connected into the main water supply to the property. The water supply is routed into the tank thereafter it goes to the pump and back into the water supply and boosts your pressure in the home/office. The size of the tank will be determined by one of our qualified technical staff as each installation differs depending on the individual needs.
Installation
The typical installation consists of a booster pump and back up water tank.
The installation should not take more than a day or two to complete with very little disruption to the client. The pump and water tank need to as close together as possible and a power supply will have to be installed at the chosen site for the pump and tank. The tank and pump are connected into the main water supply to the property. The water supply is routed into the tank there after it goes to the pump and back into the water supply and boosts your pressure in the house or office. The water is constantly going through the tank so there is no chance of stagnant water.
A supply tank is necessary for the installation for it to work effectively. If you have a pressure problem then there is not sufficient water coming into the system, there for you cannot boost the system without a backup water supply. A booster pump needs water for it to work effectively therefore if there is not sufficient water coming in the pump will run dry and cannot run at its full potential. The size of the tank will be determined by one of our qualified technical staff as each installation differs depending on the individual needs.
With a backup water tank you will never be without water again when the municipality is busy with emergency repairs and maintenance that can sometimes take days.
